Wiring A 2 Gang Light Switch For Separate Lights Uk Diagram

Do you want to wire a 2 gang light switch for separate lights in the UK? This article will walk you through the steps to successfully complete this task.

Installing and wiring a 2 gang light switch for separate lights is a relatively straightforward process that can be done by most people with basic DIY skills. It involves connecting two separate lights to the same switch, allowing you to control each with the same switch.

Before you begin, make sure you turn off the electrical circuit at the mains and check the switch is dead. It’s also important to check the connections on the light switch and ensure they are tight. Wires should be stripped back and cleansed of any dirt or debris.

You will need:
- Two or three core & earth cables
- A twin gang back box
- Two light switches
- Screwdrivers
- Wire cutters

Start by running the cables from the lighting circuit into the back box and tightening the screws to secure them. Pass the cables through the two terminals of the light switch and use a screwdriver to tighten the screws. Then connect the live cores to the “common” terminals and the neutral and earth cables to their respective terminals inside the switch.

Once everything is connected, replace the faceplate of the switch and switch the power back in. You can now test your work and make sure the lights come on when the switch is flipped. If it all works, you have successfully completed your wiring.

Following these steps will ensure that all your connections are secure and safe and you have wired your 2 gang light switch for separate lights correctly. Remember to keep your back box screwed tightly in place and make sure all connections are secure before switching the mains back on.

2 Gang 1 Way Light Switch Problem Diynot Forums