Club Car Powerdrive 2 Charger Wiring Diagram

Are you looking for a comprehensive guide to wiring your Club Car PowerDrive 2 Charger? Wiring a charger can be a complicated task, but don’t worry - by the end of this article you’ll have the knowledge you need to install your charger safely and properly.

First, let’s start with some basics. The PowerDrive 2 Charger is an efficient and reliable charger designed for electric golf carts. It provides extra power from its 24-volt motor and boosts performance when the batteries are low.

When wiring the PowerDrive 2 Charger, it is important to follow the guidelines provided in the owner’s manual. It will explain which connectors should be used and how to properly connect the wires. Start by loosening the screws on the battery terminals, then insert the appropriate connector onto the terminal posts. Make sure all of the connectors are tightened securely.

Now it’s time to connect the PowerDrive 2 Charger to the battery. Place the charger’s Output Plug into the connector, then attach the Red and Black Terminal Bands to the positive and negative battery terminals. Make sure they are firmly secured. Repeat this process with the remaining two terminals, then plug the charger into an AC outlet. The red flashing light confirms that the connection is complete.

Finally, it’s time to test the PowerDrive 2 Charger. To begin, press and hold the Mode Button for three seconds. If the LED light turns green, the unit is ready for use. If the LED light does not turn green, the unit may not be properly connected and needs to be checked.

Following these steps will ensure that your Club Car PowerDrive 2 Charger is wired correctly. Don’t forget to consult the owner’s manual for any additional information or warnings about the installation and operation of the charger. With these tips in mind, you’re ready to enjoy the added convenience and performance of your PowerDrive 2 Charger.

Club Car Schematics